Umí TomTom pracovat s modulem RDS-TMC ? nikde jsem v nastavení ani v menu nenašel tuhle položku, mám verzi 5.21 na WM 5.0.
A co verze 6 ? sice je to prý zatím bez mapy ČR ale časem nás tam snad přidají ne ? :D nejsme přeci až tak moc východní destinace nebo jim snad nic EU neříká ?
Ooo, ani verze 6 neumí pracovat s RDS-TMC přijímačem a myslím, že ani jakákoliv budoucí verze (pokud bude) to umět nebude, nutí tak zákazníky, aby odešli z PDA na jejich PND...
Zkušel jsem tu jejich službu Traffic ale furt to hlásí že nejsou žádné informace a předpokládám že to na našem uzemí ani nepojede. Naproti tomu Weather maká dobře to jsem byl překvapen.
traffic zaleze na mape :D
musis mit mapu treba GB, kde je "pokryti" ( jak jsem rikal v CR zatim nejde) :D
nevim jak to bude v TT6 :D
musis mit mapu treba GB, kde je "pokryti" ( jak jsem rikal v CR zatim nejde) :D
nevim jak to bude v TT6 :D
Nevím tohle je kopie stránky z návodu pro TomTom Go:
Chapter 17 TomTom Traffic
TomTom Traffic You can get traffic information in two ways:
• From TomTom Traffic
• From the Traffic Message Channel (TMC)
TomTom Traffic
TomTom Traffic is a TomTom PLUS service. To use TomTom Traffic you must
have a mobile phone with Bluetooth and a wireless data connection, for
example, GPRS.
TomTom Traffic takes the most up-to-date information from the best local
sources. Use the free trial to try TomTom Traffic. For more information, see
the TomTom PLUS leaflet.
Setting up TomTom Traffic
To receive TomTom Traffic, first establish a connection between your mobile
phone and your TomTom GO. See Connecting to your phone on page 43.
Then do the following:
1. Tap TomTom Traffic in the Main Menu.
2. Tap Enable Traffic.
The Traffic Message Channel (TMC)
The TMC is not a TomTom service, but is offered free-of-charge in many
countries. TMC transmits traffic information as a radio signal. To use TMC you
need to buy the TomTom RDS-TMC Traffic Receiver.
Note: TomTom Traffic is not available in all countries. Visit
www.tomtom.com/plus to check availability in your country.
Note: TomTom is not responsible for the availability or quality of traffic
information provided by TMC. TMC is not available in all countries or
regions.
Setting up TMC
To start using TMC, connect the TMC antenna to the windscreen mount. Plug
the TMC antenna into the TomTom connector.
Using Traffic
When TomTom Traffic is enabled, or a TMC antenna is connected to the
windscreen mount, the Traffic bar is shown on the right-hand side of the
Driving View, as shown below:
Traffic will immediately try to retrieve the latest traffic information.
Updating traffic information
If you are using TomTom Traffic, there are two ways to update the traffic
information:
• Tap Update traffic info in the Traffic menu.
• Set Traffic to be updated automatically at regular intervals.
To do this, tap Change Traffic preferences in the Traffic menu. Select
Automatically update traffic info while on route, then tap Done.
You are then asked if you want to limit how often Traffic is updated.
If you choose not to limit how often Traffic is updated, then TomTom will
send updated traffic information to your GO as soon as it has it.
If you choose to limit how often Traffic is updated, you are asked to set a
time.
TomTom saves this time limit and sends new traffic information at the
interval you set. If there is no new traffic information, then TomTom will not
send any information to your GO. This saves you money by not using your
wireless data connection when there is no new information.
If you are using the TomTom RDS-TMC Traffic Receiver, traffic information is
automatically updated constantly.
Using traffic information
Having up-to-date traffic information can help you to reduce your journey
time. To set your GO to use traffic information and change your route to avoid traffic problems, follow these steps:
1. Tap Change Traffic preferences in the Traffic menu.
2. Select Automatically optimise route after every update.
After your GO gets new traffic information, it will automatically optimise your
route.
Note: The best route may be the same as the route originally planned
Chapter 17 TomTom Traffic
TomTom Traffic You can get traffic information in two ways:
• From TomTom Traffic
• From the Traffic Message Channel (TMC)
TomTom Traffic
TomTom Traffic is a TomTom PLUS service. To use TomTom Traffic you must
have a mobile phone with Bluetooth and a wireless data connection, for
example, GPRS.
TomTom Traffic takes the most up-to-date information from the best local
sources. Use the free trial to try TomTom Traffic. For more information, see
the TomTom PLUS leaflet.
Setting up TomTom Traffic
To receive TomTom Traffic, first establish a connection between your mobile
phone and your TomTom GO. See Connecting to your phone on page 43.
Then do the following:
1. Tap TomTom Traffic in the Main Menu.
2. Tap Enable Traffic.
The Traffic Message Channel (TMC)
The TMC is not a TomTom service, but is offered free-of-charge in many
countries. TMC transmits traffic information as a radio signal. To use TMC you
need to buy the TomTom RDS-TMC Traffic Receiver.
Note: TomTom Traffic is not available in all countries. Visit
www.tomtom.com/plus to check availability in your country.
Note: TomTom is not responsible for the availability or quality of traffic
information provided by TMC. TMC is not available in all countries or
regions.
Setting up TMC
To start using TMC, connect the TMC antenna to the windscreen mount. Plug
the TMC antenna into the TomTom connector.
Using Traffic
When TomTom Traffic is enabled, or a TMC antenna is connected to the
windscreen mount, the Traffic bar is shown on the right-hand side of the
Driving View, as shown below:
Traffic will immediately try to retrieve the latest traffic information.
Updating traffic information
If you are using TomTom Traffic, there are two ways to update the traffic
information:
• Tap Update traffic info in the Traffic menu.
• Set Traffic to be updated automatically at regular intervals.
To do this, tap Change Traffic preferences in the Traffic menu. Select
Automatically update traffic info while on route, then tap Done.
You are then asked if you want to limit how often Traffic is updated.
If you choose not to limit how often Traffic is updated, then TomTom will
send updated traffic information to your GO as soon as it has it.
If you choose to limit how often Traffic is updated, you are asked to set a
time.
TomTom saves this time limit and sends new traffic information at the
interval you set. If there is no new traffic information, then TomTom will not
send any information to your GO. This saves you money by not using your
wireless data connection when there is no new information.
If you are using the TomTom RDS-TMC Traffic Receiver, traffic information is
automatically updated constantly.
Using traffic information
Having up-to-date traffic information can help you to reduce your journey
time. To set your GO to use traffic information and change your route to avoid traffic problems, follow these steps:
1. Tap Change Traffic preferences in the Traffic menu.
2. Select Automatically optimise route after every update.
After your GO gets new traffic information, it will automatically optimise your
route.
Note: The best route may be the same as the route originally planned
